Dozey wrote:@Legendslayer222
What's your image (this green) presents?? Mercenary??
The image = skaarjav.png which insinuates that it should be a Skaarj. So ... my guess is it's a Skaarj Avenger which is fitting because they hunt legendslayers
Post Posted: 19 Jul 2011, 20:51
Dozey wrote:@Legendslayer222
What's your image (this green) presents?? Mercenary??
Post Posted: 19 Jul 2011, 23:39
salsaSkaarj wrote:Dozey wrote:@Legendslayer222
What's your image (this green) presents?? Mercenary??
The image = skaarjav.png which insinuates that it should be a Skaarj. So ... my guess is it's a Skaarj Avenger which is fitting because they hunt legendslayers
Post Posted: 20 Jul 2011, 00:54
Post Posted: 20 Jul 2011, 07:57
Post Posted: 20 Jul 2011, 13:36
Post Posted: 20 Jul 2011, 15:14
Post Posted: 20 Jul 2011, 19:16
Post Posted: 20 Jul 2011, 19:40
Dozey wrote:xD
What is Legendslayer?? xD
Post Posted: 21 Jul 2011, 12:25
Post Posted: 22 Jul 2011, 15:43
Turboman wrote:That pic looks beautiful, very UE2'ish. Finally someone's putting 227 staticmeshes to good use
Post Posted: 28 Jul 2011, 13:30
Post Posted: 28 Jul 2011, 13:50
Post Posted: 28 Jul 2011, 16:12
Post Posted: 28 Jul 2011, 22:55
Waffnuffly wrote:Models look pretty decent, but that minigun has way way way too many barrels, and it makes no mechanical sense for there to be five barrels in the middle! If the gun spins, it's only going to be firing out of one barrel at a time (at the top or bottom, wherever the bullets are fed into the barrels), and thus would be impossible to feed bullets into the inset barrels. Unless, of course, the gun has a second motor and bullet-inserting mechanism, which would be... strange.
If I were you I'd cut the number of barrels down to 8 and leave the center open with nothing other than the big metal cylinder that supports the gun. You need a strong, sturdy thing in the center of a minigun, even if the barrels are tough, so overheating metal doesn't start to warp due to lack of support.
Waffnuffly wrote:Models look pretty decent..[...]
Post Posted: 28 Jul 2011, 23:45
Dozey wrote:Finished work will be skinned and animated.
Users browsing this forum: No registered users and 50 guests