Coronas won't show up when they get too close to decorations

[dagmarsawayn]

I'm trying to give monk and nali statues 'eyes' by putting tiny coronas in front of their faces. The coronas show up in the editor, but not in game. I tried it in UT's editor, and it worked fine, but it won't work with 227. It even worked in 224. Is there a setting I have to change to get it so that coronas won't disappear the moment I put them next to a decoration?

I'm using 227H and OpenGL, if that helps.

[ividyon]

In the Advanced Options, under Rendering -> OpenGL, are Coronas enabled?

[yrex]

Disable bBlockActors on the statues. Although that has the side effect that e.g. projectiles will pass through them.

[SteadZ]

An alternative to the above suggestion (though it would render the map only playable under 227 - and the OP suggests that you want cross-compat?) would be to set the mesh to bUseMeshCollision instead of the traditional cylinder collision (I'm assuming Yrex is thinking along the same lines as I that the corona currently sits inside the radius of the mesh which is causing the disappearance issue)

Also on a slight tangent - any reason you're using 227h instead of 227i: the most recent version?